🪔 Land Rover Discovery 3 Suspension Fault Normal Height Only

I have my first LandRover fault arise following a bit of hard core Sand Driving at Robe SA. Fault “Normals Height Only” has started to display during driving noting the following considerations - It resets every time I turn car off. - I can achieve all x3 set heights (access, normal and raised) - selector switch flashes during height After 5 miles or so, I got the amber "suspension warning" light and had these codes: C112F-72 (68) (GAP tool: "Air spring valve - Mechanical failure - actuator is stuck open") and. C1130-66 (68) (GAP tool: "Air spring air supply - Algorithm based failure - signal has too many transitions/events"). No performance issues so I carried on. Step 1: Remove the old height sensor. Disconnect the battery to avoid any electrical shorts. Locate the height sensor. It is usually located in the rear of the vehicle. Remove the sensor from the bracket by removing the bolts that hold it in place. Disconnect the wiring harness from the sensor. The Best Fix for Range Rover Suspension Problems (2022) 1. How To Spot Range Rover Suspension Problems. 2. Fixing Suspension Issues at the Dealer is Expensive. 3. Replacing Your Suspension With Aftermarket Parts. 4. An Alternative Solution for Your Range Rover Suspension Problems. In the last few thousand miles its been throwing up a 'suspension fault' message either at start up or during the journey. It will say stay below 30 if i drop below that speed and increase again. The suspension doesn't drop, or seem to when left. So to sum up On an LR3/4, the fender to axle height is 465mm front, 485mm rear per factory. You gain an additional 50mm of static height with Off-Road setting. With tools like LLAMS, IIDT, or rods, we can raise static ride height far higher. However, this comes at the expense of downward travel and excessive CV angles. I have a 2010 RRS 5.0 SC that had a suspension fault come up on the dash during normal driving conditions. I used my iid tool and found the following codes. U0421-68 (2B) Invalid data received from ride level control module. U0421-68 (2F) Invalid data received from ride level control module. U3000-1D (AF) Control Module -General electric Only Normal Height Available. Every day after a couple of minutes driving I get the "Only Normal Height Available" warning and yellow triangle. This is an early D4 with 190,000 relatively trouble free miles. LR garage says a new compressor is needed and they are quoting me £900 ! Car drives just fine and no perceptible suspension issues. Apr 22, 2017. #1. So, we managed to get Storey Wilson's software (4CAN) working on my mate's 2007 Disco LR3. The fault read was exhaust valve! Cleared the fault and managed to recreate it by going up and down. The fault occurred while trying to lower. On the live pressure readings we saw a spike in pressure after asking the car to lower, the A few kms down the road i got the bing bong suspension normal height only as i was in that mode. Got to where i was going had a look but could not find where it was coming from. The next day was driving through tracks all day when at the end of the day bing bong suspension fault at the raised level. L319 Discovery 3 and 4. I was getting the same Suspension Fault, Normal Height Only message as mhewitt on a regular basis. LAND ROVER and its logo are the I got the dreaded yellow light and Suspension fault - normal height only warning this morning on my way to the shops. Asked my daughter to check if the brake lights were working when I parked which they were. After shopping I turned the key and let it do the diagnosis before starting the engine. All was fine. cYaoS1.

land rover discovery 3 suspension fault normal height only